ASCOM 21 Manual de usuario descargar pdf (Pagina 40)

TD 92477GB

2009-03-18/ Ver. B

User Manual

Ascom d62 DECT Handset

7 Enter the number.

8 Press "Send".

7.4 Receive a Message with Request for Answer

Note: This feature is applicable for d62 Messenger and d62 Protector only.

In the status bar, a message with request for answer is indicated the same way as an

ordinary message, see 7.3 Receive a Message on page 31.

In the message list, the message with request for answer is indicated by the icon.

7.4.1 Accept/Reject the message

Press the soft key “Accept” or “Reject”.

When an acknowledged message has been replied to, the icon is shown in the

message list. The text “Accepted” or “Rejected”, and time and date is also added in the

acknowledged message.

Note: The option “Delete” is not available for a message with request for answer. An

unacknowledged message can only be deleted from the message list.

7.5 Message Queuing and Message Priority

Note: This feature is applicable for d62 Messenger and d62 Protector only.

The default settings is that each message will be displayed without being interrupted by

another message, except if the new message is of higher priority. Messages that are not

shown yet are placed in a queue and the priority and time of reception determine the

position in the queue. There are 9 levels of the priority. 1 is highest priority and 9 is lowest

priority.

If several of the messages have the same priority the message that was received first is

shown first.

If a new message with a higher priority is received while another message is read the new

message will replace the old message in the display. The old message will be placed in the

queue. If a new message with equal or lower priority is received while another message is

read the new message will be placed in the queue.

It is possible to configure how long a message will be displayed, see Configuration

Manual, Ascom d62 DECT Handset, TD 92639GB.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 77 78

Sin comentarios

ASCOM 21 Manual de usuario Pagina 40