ASCOM TD 92417GB Manual de usuario descargar pdf (Pagina 14)

TD 92417GB

2009-03-11/ Ver. C

User Manual

Ascom a71 Alarm Tranceiver and Ascom p71 Transceiver

4 Basic Operation

Note: The transceiver may have functions other than described, depending on the pre-

programmed parameters.

4.1 Switch the Transceiver On/Off

To switch the transceiver on:

1 Press and hold .

2Press "Yes" soft key.

To switch the transceiver off:

1 Press and hold .

2Press "Yes" soft key.

4.2 Mute the Transceiver

1 Press and hold the “Mute” button. is shown in the display.

4.3 Lock the Keys Manually

1 In stand-by mode, shortly press .

2 Press "Yes" soft key.

To unlock the keypad:

1Shortly press .

2 Press "Yes" soft key.

4.4 Charge the Battery

Charging is done in a single charger or a wall mounted charging rack. It is recommended

that the transceiver is charged daily.

Note: Charge the battery for at least two hours before it is used the first time.

A flashing orange LED indicates charging. A green steady LED and a filled icon shows

a fully charged battery. It takes approximately two hours to charge the battery. An empty

battery icon in the display and a warning beep signal played once every minute together

with a fast flashing red LED indicates an empty battery. Put the transceiver into the charger

to load the battery.

To replace the battery, see Replace the Standard Battery on page 28.

Note: While charging, Man-down & No-movement alarms are automatically deactivated.

The Location Function (IR and LF) is also deactivated. (If a push-button alarm is sent, the

last stored location before charging the transceiver, is sent).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Sin comentarios

ASCOM TD 92417GB Manual de usuario Pagina 14